DC8000不识别电极丝，求大神
 

这个应该是不识别电极丝吧，把鼓架都对换了，还是只是提示红色问题 一直提示这个，哪位大神了解情况，谢谢啊

这个说的是电极丝没装好，严格来说并非“不识别”

9-501 CC Unit Not In Position 2 RAP
Description
A pop-up message is displayed on the UI indicating that the CC Unit is not properly installed in position 2.

Initial Action
Refer to BSD 9.28 Figure 45 for this procedure.

Enter DC330 009-125 CC M Detect. Select Start. If High ( H) CC detected, if Low ( L) CC not detected.

Procedure
+24 VDC is present between J469-A11 at Flag 3 and GND when the magenta Charge Module is removed from the machine.
Yes No Unanswered

Perform the following checks:

Go to Flag 3 and check for an open circuit.

Replace the ESB HVPS Assembly (M) ( PL 5.2)

+24 VDC is present at J469-A11 when the magenta Charge Module is installed in the machine.
Yes No Unanswered

Replace the IOT PWB ( PL 13.3).

Replace the ESB HVPS Assembly (M) ( PL 5.2)