施乐j75 定影器换完加热膜和压辊 报010-321求路过的大神指点下
 

初学修，打印机第一次拆完定影就报代码了:bad_egg:
求大神知道
另求大神知道如何入门修机子……

既然动过定影器 之后发生的错误代码
那么还是要先检查定影器
是否没有连接好 或者 没有安装到位

施乐j75 定影器换完加热膜和压辊 报010-321求路过的大神指点下
 

010-321 Fusing Unit Nip Fail
Bsd-on:CH10.1

Nip or Release operation error of the Fusing Unit was detected.


This Fail is a Sub System failure and its occurrence cuts off the +24VDC_C13. (Refer to BSD CH1.7)

Cause/Action
Check the following:

The Fusing Unit Nip Sensor (DC330 [010-203]) for operation failure. (PL 7.6)

The Sensor Actuator for damage. (PL 7.6)

The Gear of retract mechanism for wear and damage.

The One Way Clutch for skidding.

The Drawer Connector ( DP612/ DJ612) for poor contact.


If no problem is found, replace the MCU PWB. (PL 18.2)

010-321 Fusing Unit Nip Fail
Bsd-on:CH10.1
Nip or Release operation error of the Fusing Unit was detected.
This Fail is a Sub System failure and its occurrence cuts off the +24VDC_C13. (Refer to BSD CH1.7)
Cause/Action
Check the following:
The Fusing Unit Nip Sensor (DC330 [010-203]) for operation failure. (PL 7.6)
The Sensor Actuator for damage. (PL 7.6)
The Gear of retract mechanism for wear and damage.
The One Way Clutch for skidding.
The Drawer Connector ( DP612/ DJ612) for poor contact.
If no problem is found, replace the MCU PWB. (PL 18.2)

这个代码也是我最心惊肉跳的代码，也是最悲剧的代码，现在想想也后怕。:electric_shock:

定影器方面 撇开驱动部分的原因导致的错误代码
一般都容易让技术和客户闹心