bizhub PRO 1200/1200P/1051 Troubleshoot
No J1
Category: Jam
Date of issue: September, 2010
Go to INDEX
J-2101
[Symptom]
Drum wrapping jam occurs when using specific paper.
[Cause]
Transfer value and transfer timing is inappropriate.
[Solution]
Change the transfer current value in the MICHINE screen as follows. (Transfer leading edge1, 2 only)
[Tray Setting]-[Change Set]-[Process Adj.]-[Transfer Offset Adj.]
Step1
Increase offset value at leading edge1. (by 10 step)
*: When belt separation and leading edge image quality were deteriorated, decrease the value.
Step2 (If Step1 is not effective)
Decrease the value of the leading edge1 and 2.
*: When the transfer fails at the leading edge section, increase the value.
Then, register the name of the paper. (Can be register up to 100)
Others
The symptom occurs at the burr of paper cutting area too. Turn around and feed the transfer paper. When jam does not occur, change paper setting direction so that the paper cutting area of the jam becomes the tailing edge of paper cutting area. Transfer value off set is the direction that the minus direction is improved.
Caution
Never perform the transfer current adjustment in service mode.
這好像似官方解決的方法
可是英文看不懂 有人能翻譯的嗎