4-330 Belt Edge Sensor Fail RAP
Description
Fault Code 4-330 indicates that the IO PWB detected irregularities in the Belt Edge Sensor.
Initial Action
Refer to BSD 9.15 in the following procedure
Reseat the P/J for the Belt Edge Sensor in the following procedure.
Procedure
DC330 Code to Check
[004-013] IBT Drive Motor ( PL 3.4) (Listen for the motor to energize)
Check Items
Go to BSD 9.15 and troubleshoot the Belt Edge Sensor circuit ( PL 3.4).
Replace the Belt Edge Sensor (Belt Edge Sensor )
Go to the Eureka Web Site and check if there is an Eureka Tip for this procedure.
If unsuccessful, escalate to the next higher level of support.