[sbynimtd]

海德堡四组520处都有同样的杠子：
我们在印盒子时，第3组520处有一杠子。搞了很长时间没有好，我们只调色组，但是这一组在同一位也有，最后又调一组还有在同一位。没有办法！+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

[HOMEZHENG]

没看明白，说说清楚，也好帮你。

[exiled2304]

看不懂 看明白，说说清楚，也好帮你。

[yanquan76]

1.检查胶辊2压力及轴承2.检查窜墨换向时间与改变窜墨量，看有无位置变化3.润版液指标、油墨指标4.检查压力5.检查齿轮及过桥齿轮6.检查滚筒轴承

[ggf987654]

换一种规格的纸，看看是不是杠子随纸宽度在变，如是建议你查一下压力是不是太大，有冲击杠，还要看看传墨辊压力有没有偏大。

[OoGOoO]

作者: yanquan76

1.检查胶辊2压力及轴承2.检查窜墨换向时间与改变窜墨量，看有无位置变化3.润版液指标、油墨指标4.检查压力5.检查齿轮及过桥齿轮6.检查滚筒轴承

如果这样的检查都差不多了，我想是整是有跳动了，不然没理由每一座都都有都是同一个位的，这样我见意你查一下主动轴还有是主动马达呢〜！！

还有一个就是纸的问题都有，是不厚纸，纸纹是不是顺，不然可以反打，这样多在后面呢！！？墨大不大，湿不湿〜！！