[lypsky]

The problem consists in an overabundance GUM on the form - it is necessary to check pressure between GUM shaft on development or to try to reduce submission GUM or in general to disconnect submission (only for check).
It is possible to try clean off GUM by the printed machine.
If the problem was not solved, it is necessary to check up humidifying by the printed machine.

Here still the moment, has forgotten. It is necessary to check up blank space on the form, probably brushes in developer badly rub the form and polymer is badly washed away (are dirtied or backlashes)

[lypsky]

我寫在俄羅斯，然後翻譯成中文，或許是，了解一下。中國不知道。

這個問題包括在一個過剩口香糖的形式-這是必要的檢查與膠軸壓力的發展，或者設法減少提交膠或一般斷開提交(僅限於檢查)。有可能嘗試過膠的清理印刷機器。如果問題不解決，要檢查加濕的凹版印刷機。這裡仍是目前，已忘記了。要檢查空白的形式，可能刷擦開發急需的形式和聚合物嚴重流失(是打噴嚏或反彈)

[lypsky]

你可以'奶' - PlateCleaner摩擦更加強烈，右鍵窗簾的形式。